I Made Dis: Sparkly Ear Cuff

by sassandbite

First of all, let’s get the important things out of the way: today’s date is 11/12/13. The fact that I get to write this on the date line for all the messages I take at work today is very exciting for me.
It’s the little things.

P1010188

Speaking of little things, I made an earring/ear cuff hybrid. I saw this on HonestlyWTF a while ago, and my mind-numbing boredom and love of sparkly objects combined forces over the weekend to get me to make one. And I like it. It’s like a sparkly bluetooth.

Mine is less intricate and slightly different than the original; the stones I used are somewhat wider and I didn’t get settings to make them flat because A) I didn’t realize I needed to, and B) I probably wouldn’t have anyway because it would have required me to go to a specialty store and I’m too lazy for that. Except I had to do anyway the next day because even though I had an earring-back fastener, I didn’t actually have the pointy earring post part. Which you’d think would be pretty obvious and at the top of the list, but no. Not in my brain. Didn’t even occur to me until I tried to put the thing on.

I’m a mess. I also spent a whole day unaware that my underwear was on backwards. So. You know. Me in a nutshell.

It's actually really sparkly in real life.

It’s actually really sparkly in real life.

Anyway. It’s pretty simple. All you need are:

  • some gems, beads, whatever — I’m making another one involving a pearl that I haven’t finished yet — I got my navette stones in the bead section at Michael’s
  • curved tube finding, also in the bead section at Michael’s
  • earring post with a flat backing; I got mine at a bead store because I just wanted one set, but you can also get them at Michael’s
  • earring back; I took mine off an old earring with no mate
  • super glue
  • a hammer
  • needle-nose pliers and a toothpick, if you want more precision

P1010147

First, use the hammer to flatten the tube.

Apply glue to the back of the bead — you might want to use a toothpick so it doesn’t get all over the place, which it will because superglue is unreasonably difficult — and set it where you want it on the flattened base.

I used just the tip (badum kssh) of the bead and set it on the edge; hold it there for a few seconds to give the glue time to set a little bit.

Continue the rest of the beads, alternating to form a leaf-like pattern.

When you get to the end, if there’s excess metal trim it off with wire cutters. If you don’t have wire cutters, there’s often a hidden set in the joint of needle-nose pliers.

Glue the earring post to the back of the flattened base, not too close to the end because you don’t want it to fall once it’s in your ear.

Let the whole thing dry for at least several hours, or overnight before wearing.

*If you managed to somehow get superglue all over the damn thing and it dulled the stones (not that I speak from experience or anything), go over it with a Q-tip dipped in nail polish remover: it’ll dissolve the glue on the surface. Then go over it with a Q-tip dipped in water so the acetone doesn’t dull the stones or seep into the setting and dissolve the glue.

Wear and look stylish.

 

Advertisements